9.2.4.13. Ruckus SmartZone

9.2.4.13.1. SmartZone configuration

Webauth

First, you will need to define your RADIUS server configuration at the OpenNAC Server

Then, create a Hotspot in Configuration → AP Zones → Your Zone → Hotspot WISPr → Create New. Adjust 192.168.1.5 to the IP address of your portal.

../../../_images/ruckus-smartzone-webauth-hotspot.png

Still on this page, in the Walled Gardens, make sure you add the portal IP address in this list.

You will need to configure your WLAN to use the Hotspot authentication and point it to OpenNAC Enterprise. Also ensure you set Use the controller as a proxy.

../../../_images/ruckus-smartzone-webauth-ssid.png

After that, the configuration should be carried out at OpenNAC Enterprise.